Sentence examples for surface voids from inspiring English sources

The top layer was two inches thick, using three-fourths- to one-inch stone to fill surface voids between the large stones.

The GST film grown on a Si3N4 surface appeared to have many surface voids.

The GeSb8Te film grown on a Si3N4 surface showed a similar surface morphology with a slightly smaller average grain size (approximately 70 nm) and without surface voids.

Bugholes are surface voids that result from the migration of entrapped air to the fresh concrete-formwork interface.

The SEM images show the status of machined surface in terms of surface voids, adhered oxides and chip particles, feed marks, material side flow, un-machined material, rough and smooth surface.

The porosity of the graphenic carbon film is determined by the surface voids of the nickel film resulting from grain coalescence during annealing.

The polyurethane films exhibit smooth surface, void-free and transparent (Fig. 2a).

R ave and R rms average and root mean square surface roughnesses, respectively, VF surf surface void fraction.

The results show that local IRSTs can vary according to the local compositions of the foam surface (void and solid).

The surface void fraction is important specifics of nano-sculptured thin films which are produced by oblique angle deposition and self-shadowing effects.

Figure 2i iii shows the 2D and 3D AFM images (columns I and II) as well as surface void/inclusion fractions (column III), while in Table 1 the results of grain size distribution, percentage of surface void fraction (measured using JMicroVision software) and also average and root mean square surface roughness for all samples produced in this work obtained from the AFM results are given.