Sentence examples for surface of the section from inspiring English sources

This failure mode appeared to be related to the presence of micro-cracks on the surface of the section obtained by overheating during extrusion.

It is shown that the effects of geometrical imperfections are most prominent for strut designs with near simultaneous buckling and yielding and that the ultimate failure and unloading of strut designs, in general, is synonymous with the development of yielding at the section junctions along the full length of the struts and through to the middle surface of the section walls.

A second approach consists of using μ-XRD in transmission mode (Figure 4 c, right), the surface of the section can then be perpendicular to the beam.

Serial Z-sections were collected in 1 µm steps from the surface of the section to a depth of 50 µm.

The x and y shifts were obtained from the coordinates of the gold particles that were deposited on the surface of the section.

The area of the counting frame was 3521.2 µm2 and dissector height was 8 µm with a guard zone of 2 µm from the surface of the section.

Usually, both sides and the bottom surface, of the sections of beams, columns, and similar members in a building are exposed to fire during an accident.

The yield surface of the sections is defined by its support function values associated to presso-flexural mechanisms and it is approximated as Minkowski sum of ellipsoids.

Only CTB-positive cells whose nucleus was partially or entirely present in the section, but did not contact the surface of the sections, were counted.

Mitotic cells located near the surface of the sections (hence without a 30 μm area around them, which were less than 10% of all PH3 + cells identified) were excluded from this analysis in order to avoid missing the nearest blood vessel that might be outside the section.

A three-dimensional geometric drawbead is a lofted surface, of which the section curves are constructed parallel to the stamping direction on the control points.