Sentence examples for surface of the roof from inspiring English sources
The Pakistani artist Imran Qureshi, who is known for his painstaking brushwork in the style of the 16th- and 17th-century Mughal miniaturists, is conceiving a site-specific painting that will be directly on the surface of the roof garden.
Sensitivity of modeling results to uncertainty in the calculation of the convection coefficient is explored, showing there is high sensitivity in the prediction of the heat transfer normal to the surface of the roof, but low sensitivity in the prediction of the rate of ventilation airflow through the house and the temperature of the roof surface.
Mold removal is done with wet methods that make the surface of the roof slippery.
Use a chemical sold commercially for mold removal, or a 50/50 combination of water and bleach to saturate the surface of the roof.
The flange provides a surface with which to attach the vent to the roof, and also helps to prevent leaks between the vent and the surface of the roof.
Eero Saarinen's T.W.A. terminal at Kennedy International Airport, for example, was denounced by purists because the smooth concrete surfaces of the roof belied the vast amount of steel it took to hold it up.
Wind pressures were measured simultaneously at many points both on the top and bottom surfaces of the roof model for various wind directions.
Wind pressures were measured simultaneously at many points both on the upper and lower surfaces of the roof model for various wind directions.
The neuronal activity was recorded at each step to monitor the topographic transition from the opercular surface to the roof of the calcarine sulcus, which was the region of interest in this study.
The effects of cool surfaces (on the roofs, on the street pavements or as vegetation areas) are evaluated through numerical simulations using the software ENVI-met.
In the pressure test, because the applied pressure was equivalent to the pressure on the entire surface area of the roof, the billowing heights of the PVC sheet around the fastener had almost the same maximum values; therefore, the axial force at the fastener was also similar to the pressure induced by a compressor, and no lateral forces were measured.
