Sentence examples for surface of the peptide from inspiring English sources
They almost covered the entire surface of the peptide scaffolds.
In the case of cells in PRG 10% scaffold, the cells were attached on the surface of the peptide scaffold and did not penetrate into the scaffold (A2).
The signal intensity that we measure on the array is assumed to be proportional to the ratio of bound-to-total surface of the peptide spot, S i.
LESCs were successfully cultured on the inner surface of the peptide modified contact lens without affecting LESC morphology and phenotype compared to cells grown on glass coverslips and 10(b)).
Especially for transmembrane proteins where no or little structural information is available, the interaction of peptidic toxins can be used to gain structural information of the target protein by using the interaction surface of the peptide as a fingerprint of the interaction surface of the target.
The surface of the peptide-coated AuNV appears rougher and thicker (red arrow) than the PEG-coated AuNP, indicating successful conjugation (scale bar = 10 nm).
Grafting 0.025 m of GRGD-SANPAH (N-Succinimidyl-6-[4′-azido-2′-nitrophenylamino]-hexanoate) solutions to chitosan and tripolyphosphate anhydrous crosslinked chitosan (chitosan-TPP) surfaces was performed by surface adsorption of the peptide and subsequent ultraviolet (UV) irradiation for photoreaction.
Periodontal ligament fibroblasts adhered to the surface of these peptides recognized the adhesion motif inside of the scaffold as well and then migrated into these scaffolds.
Activation of the pHLIP-FIRE at neutral pH might occur due to (i) membrane insertion of some amount of the construct at pH 7.2 7.4, since there is an equilibrium between inserted and surface locations of the peptide, or (ii) endocytotic uptake of the peptide adsorbed at the membrane surface, especially since the time course of the experiment is several days, or both.
The successful surface coating of the peptide is supported by FT-IR and XPS spectroscopies, chemical quantification, and antibacterial assays.
The hydrophobic solvent-accessible surface area of the peptide, in contrast to the hydrophilic counterpart, is largely reduced upon confined in both MOFs because of the favorable interactions between hydrophobic residues and MOFs.
