Sentence examples for surface of the casing from inspiring English sources
The rotor turns in a closed chamber, and the three apexes of the rotor maintain a continuous sliding contact with the curved inner surface of the casing.
In this paper, thermal stress concentration factors for the inner surface of the casing and valve are defined to account for variations in the geometry using three-dimensional finite element analysis.
A simplified procedure, which can be easily programmed on a digital computer, is presented for experimental stress analysis through strain gauge measurements on the surface of the casing during test.
The three apexes of the rotor are provided with spring-loaded sealing plates that maintain a continuous sliding contact with the concave inner surface of the casing, and the combustion chambers increase and decrease successively in size as the rotor turns.
We thus created a long tunnel in the polony about 20 mm from the surface of the casing.
A short bath in potassium ascorbate prevents growth of bacteria on the surface of the casing.
Sausage sliminess is the result of heavy micro-organism growth on the surface of the sausage casing, encouraged by too high a temperature and air humidity.
After that, the surfaces of the epoxy casing are grinded down to the problem area, and polished for better visiblity.
At a distance of 30 m from this footbath, there exists a small outpouring of hot-spring water and gas bubbles at the surface due to fracturing of the casing pipe, and it is within this surface outpouring that the temperature monitoring sensor was placed at the ASY site.
In this paper, we apply digital image correlation (DIC) technique to monitor strain development over the surface of a casing filled with cement while it is diametrically compressed.
Through appropriate machine selection under consideration of the respective hydraulic boundary conditions and, if required, in association with a mechanical optimization of flow-guiding components (e.g., smoothing the surface of impeller and casing, reworking of the impeller's geometry), PAT-efficiencies in the range of 80%% are feasible.
