Sentence examples for surface of samples from inspiring English sources

The 3-D surface of samples had a multifractal nature.

To peruse the wear mechanisms of worn out surface of samples were investigate by SEM images.

Only γ-FeOOH was observed on the surface of samples polarized at pH 6.6.

The worn surface of samples treated at higher temperatures is covered with rough sliding tracks.

It has been shown that the tensile fracture surface of samples can show facetted regions characteristic of a brittle fracture and regions which appear ductile.

The SEM, EDS and Atomic Absorption Spectroscopy showed the deposition of apatite layer on the surface of samples showing a good bioactivity.

Moreover, in vitro bioactivity of the nanocomposite coatings demonstrated enhanced Ca-P precipitation on the surface of samples with increasing forsterite content.

After 100 minutes diffusion, pasting simulation results (Fig. 4a and Fig. 4b) on the surface of samples, we dug up a lot of cylinders (the diameter is 4 mm) in the vertical straight lines (Fig. 7a), and measured the chloride ions concentration by NJCL Chloride Ions Concentration Fast Measurement Equipment.

Initially, fracture process zone development was investigated only on the surface of samples using Digital Image Correlation which is a non-destructive optical testing method.

The worn surface of samples without heat treatment or heat-treated to lower temperatures is covered with a smooth but loosely-bonded layer of wear debris.

Moreover, in order to observe the effect of corrosion on the surface of samples, we have utilized SEM analysis after the corrosion test.