Your English writing platform
Discover LudwigExact(26)
Kipness estimates he spends 72 hours a week handicapping, though he said he would not spend much time worrying about the synthetic surface angle.
The optimal combination of key structural parameters of the XSJ joint is taper 1 16, thread pitch 6.55 mm, guiding surface angle 29°, bearing surface angle 28°, and tooth height 3.755 mm.
The MIT team was able to adapt the equipment to operate with a weaker vacuum, and with the ability to change the surface angle and to push and pull droplets across the surface with a tiny wire.
A surface angle analyzer demonstrated that water contact angles of IOP1, IOP2, IOP3 and MS2 were 44.83, 64.00, 34.33 and 33.00°, respectively.
The main result of our analysis is the proof of feasibility of the complete isolation of all primary actuator/surface faults in the nominal case by using a minimal number of additional surface angle sensors.
As the rotation axis of the module is in the plane of the reflector surface, angle dependent experiments can be made to distinguish between film and particulate type contamination of samples.
Similar(34)
With this algorithm, sharp corner uncut can be detected by calculating the surface angles at their common edges.
Consequently, tilt adjusted values of surface and dive angle were also calculated, where surface angles from adjacent radii were used to adjust the measured dive angles.
SURFACE angled in and chased outside a rival, came out in upper stretch and was edged for a minor award.
The top and bottom edges of the belt were tapered, the outer surface angling in 200 mm from the edge to a thickness of 45 mm.
After the test was finished, the surface contact angle and rolling angle could still reach 152.2° and 5.4°, respectively.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com