Sentence examples for support designed and constructed from inspiring English sources

This article presents and discusses the results of measurements of solar radiation and wind speed obtained during the operation of a test-bed hybrid wind/solar generator with hydrogen support designed and constructed at the Industrial Engineering School at the University of Extremadura, Badajoz (Spain).

This article presents and discusses the results of an exergy analysis conducted during the operation of a test-bed hybrid wind/solar generator with hydrogen support, designed and constructed at the Industrial Engineering School of the University of Extremadura, Badajoz (Spain).

This paper describes a clinical trial undertaken to determine the basic functioning of a clinical decision support system (CDSS) designed and constructed by the authors to facilitate the control of the major cardiovascular components in the early post-operative phase.

IHI, with technical support from CSIRO, designed and constructed the "PICA pilot plant", for the continued development of an advanced PCC process, which will enable a reduction in the CO2 capture absorbent regeneration energy by 40% compared to the conventional MEA based process.

To accommodate the influx of athletes and coaches, quarters for competitors and support staff were designed and constructed, with three new facilities (forerunners of the athlete's villages of later Games) built.

An advanced carbon paper (CP) macro-substrate (current collector)/submicro-carbon sphere chains, CSCs (catalyst support)/Au (nanocatalyst) architecture was designed and constructed.

A special device was designed and constructed to support the measuring instruments.

In this study, a new thermal hydraulic integral test facility the advanced core-cooling mechanism experiment (ACME was designed and constructed to support the CAP1400 safety review.

Closely spaced layers of geosynthetic reinforcement and compacted granular fill material can provide direct bearing support for structural bridge members if designed and constructed properly.

In Figure 4, a 2-layered gateway system is presented, but the system is designed and constructed to support more than 2 layers of the gateways to distribute heavy traffic loads over the entire system when the number of active PHD agents at once is very large.

A novel black-to-transmissive electrochromic device based on TiO2-supported viologen and triphenylamine derivatives was designed and constructed via the absorption-complementary approach.