Sentence examples for substrates and procedures from inspiring English sources

The vast majority of studies in this area make use of the classical coagulation equation of Smoluchowski, and while developed primarily for coalescence phenomena, it has been adapted and modified extensively to describe particle aggregation for many different substrates and procedures for inducing aggregate formation.

IgG was detected by using commercial peroxidase anti-horse IgG and tetramethylbenzidine as the substrate and standard procedures of ELISA capture.

High production cost of PHB production is mainly devoted to the expensive carbon substrates and tedious production procedures [10].

The elastolytic activity of LasB elastase was determinate using elastin Congo red as substrate and the procedure was modified from that described previously [ 48].

All of the parameters, such as geometry of the substrate, preparation procedures and test parameters remained unchanged for all the SLJ's produced.

As control substrates, imprinting procedures were carried out using albumin (BSA imprinting substrate) and without imprinting protein (non-imprinting substrate).

With regard to the dental substrates, adhesive procedures are usually performed to achieve bond to dental enamel and dentin.

Contact angle measurements were used to reveal the effect of various substrate cleaning procedures including sonication and UV ozone treatment prior to casting a 35 μm coating.

Nanowire (NW) TiO2 electrodes, either rutile or anatase phase, were prepared by chemical bath deposition (CBD) on FTO (F SnO2) conducting glass substrates using analogous procedures with different precursors.

Key aspects considered include: i) donor animal species and number of animal used, ii) diet fed to donor animals, iii) collection and processing of rumen fluid as inoculum, iv) choice of substrate and incubation buffer, v) incubation procedures and CH4 measurements, vi) headspace gas composition and vii) comparability of in vitro and in vivo measurements.

Micrometre-sized nanowire patterns (both Cu and Ag) were fabricated on glass substrates, using the procedure shown in Figure 2. Electrodeposition had selectively taken place on the exposed metal area (which act as pads), initially defined by the lithography, due to the insulation of photoresist.