The phrase "strength of test" is correct and usable in written English.
You can use the phrase to refer to the difficulty, rigor, or effectiveness of a given test. For example, "The strength of the math test was higher than expected, so students had to work hard to succeed."
We briefly evaluated the bonding strength of test wafers after the bonding test.
Their influence on three responses such as tensile, flexural and impact strength of test specimen is studied.
Compressive and splitting tensile strength of test cylinders as well as load deflection and cracking behavior of test beams with variable fiber contents have been evaluated.
The RKS model was able to predict the rheological properties (slump flow, passing ability and segregation resistance) and compressive strength of test mixes which were familiar and unfamiliar to the model.
As the alkali content of cement increased, rapid and significant expansion due to ASR was observed in HPCM, along with significant loss in flexural strength of test specimens, even though the w/c was maintained at 0.20.
RMS stands for root mean square, and Ra stands for the arithmetic average of absolute topographic height Table 7 Results of [Experiment II] Temperature [°C] Rupture strength (MPa) 100 1.988 400 3.394 600 2.654 800 5.836 1000 >10.04 The rupture strength of test pieces for each annealing temperature from 100 to 1000 °C.
fcu is the strength of tested cube for the concrete.
Nonlinear 3D finite element model was developed to simulate the monotonic behavior and strength of tested specimens.
According to Landis and Koch [ 35], the strength of test-retest agreement for ICC is classified as follows: below 0.20 is poor; 0.21 to 0.40 shows a fair agreement; 0.41 to 0.60 indicates a moderate degree of agreement; 0.61 to 0.80 means substantial agreement; and 0.81 to 1 indicates almost perfect agreement.
Each patient admitted into the study was assessed for both range of motion by the pre-angles of ROM effects and strength of testing.
Studies have shown the relationship between the amount of fibers in polymer matrix and the flexural strength of tested reinforced materials [ 15– 17].
