Sentence examples for strength of prepared from inspiring English sources

The tested average cubic compressive strength of prepared ECC was about 50 MPa, and the corresponding prismatic compressive strength was approximately 45 MPa.

The gel strength of prepared gel samples was measured using the breakthrough vacuum method as shown in Fig. 1 (Zhao et al. 2015).

The tensile strength of prepared membranes is in the range of 5.8 30.9 MPa while the elongation at break (Eb) of 118.9 447.2%.

These investigations were done by X-ray diffraction (XRD), scanning electron microscopy (SEM), infrared spectroscopy (FTIR), measurement of specific surface area, pozzolanic activity and mechanical strength of prepared geopolymer mixtures.

The fracture strength of as prepared composites is 400 600 MPa.

The response variables were tensile properties and impact strength of the prepared samples which are directly affected by the blend microstructure.

Moreover, the compressive strength of the prepared 91% high-porosity cement foams was enhanced by addition of metakaolin and silica fume.

In order to estimate the ultimate tensile strength of the prepared composites, a mathematical formulation was derived, and test results were compared with those of the model.

The hydrophilicity, porosity, pure water flux, mean effective pore size and breaking strength of these prepared membranes increased with increasing the HBPE content.

Cyclic voltammetry (CV) and Scotch®-tape test were employed to characterize the electrochemical properties and adhesion strength of the prepared micro gold devices, respectively.

The tensile strength of the prepared composites nearly doubled when 3-aminopropyl-trimetoxysilane was used as compatibilizer, in comparison to the composites prepared without additives.