Sentence examples for strength of interface from inspiring English sources
This paper focused on the ultimate strength of interface weld connection between gusset plate and frame elements when the brace is in tension.
The effect of adhesive strength of interface on the mechanism of crack propagation along the interface of metal/ceramics nanocomposites is illustrated in detail.
Such interfacial fracture phenomenon has been widely studied by using fracture mechanics based applicable analysis to model and predict the fracture strength of interface in film systems.
In addition, the Vicker hardness measurement was performed for the cermets, and the hardness was influenced by several factors, such as volume fraction and composition of binder phase, average grain size of ceramic phase and bonding strength of interface.
The results indicate that when the shear strength of interface is lower than a critical value, obvious slippage between barrier layer and pay layer occurs, the fracture tip becomes blunted, and thus the fracture height is controlled.
Then, strength of interface and its share in increasing tensile toughness and strength were calculated in a case study of composites containing M23C6 particle reinforcement in matrix of 1.2542 tool steel.
The inclined impact test is an efficient method for characterizing the fatigue strength of interfaces of nanocrystalline diamond coatings (NCD).
The adhesion strength of interfaces was evaluated for two Cu/polyimide laminates, which had the same interface but different polyimide film thickness.
In this paper, we investigate the mechanical strength of interfaces in double-walled carbon nanotube (CNT -reinforced aluminum (Al) nanoCNT -reinforcedsing in situ electron microscopy naluminumnicAl sinanocomposites-out techniques.
Various factors influence the bond strength of interfaces, such as the physical, mechanical and chemical properties of structural adhesives and adherends, the shape of adherends, water immersion, adhesive layer thickness, bonded area geometry, relative humidity and temperature of the environment during curing and service life, the amount and type of fillers and surface finishing of adherends.
The bonding strength of interfaces in cemented arthroplasty systems has been evaluated using conventional mechanical testing, such as reported in [5 10].
