Sentence examples for strain areas from inspiring English sources

Bicortical screws, while presenting reasonable stability, showed high strain areas near the anterior ramus ridge, superoposterior to the screws, implying a risk of bone fracture in this area.

In order to arrange the strain gauges at the appropriate strain areas of the leaf spring, the relationship between the geometric parameters and the strain distribution of the leaf spring was also investigated by FEM.

Fine grained (standard SPF) In718 presents an acceptable superplastic behaviour which allows for the design of complex components involving localized high strain areas, where final sheet thickness predictions become essential for the design of a component.

According to the observations of XRD, HRTEM and the highest bireflectance in shear zones (Table 1), frictional heating or stress-chemistry of shearing strain areas might play a more important role in increasing brittle deformation than the area with low or no strain.

It also shows that the productive wells lies in the low shear strain area and the nonproductive wells in the high shear strain area.

The reservoir is productive in low strain area, as this is necessary for the trap generation.

The shear strain contour map implies that the producing gas wells (Sawan-01, Sawan-02, Sawan-03) lies in the low shear strain area whereas the dry wells (Gajwaro-01, Nara-01) falls relatively in the relatively high shear strain area.

The standard method for obtaining the elastically stored strain energy is computing the area under the stress strain area that is bounded to the right by the unloading path.

The calculations show that, in order to maximize the output power of a PVEH, the electrode should cover the piezoelectric layer from the peak strain area to a position, where the strain is a half of the average strain in all the previously covered area.

If we use the other crack model estimated using the InSAR data (Doke et al. 2017) to calculate the strain change, a large volumetric strain area of more than 25 μm is also produced around the vents (Additional file 4: Figure A4).

It is therefore impossible to resolve vertically the position of iso-strain areas for the capped QDs with our GID measurements.