"straight line paths" is a grammatically correct phrase and can be used in written English.
Example: The drone followed the straight line paths between the buildings, capturing stunning aerial footage of the city.
Because ray tracers inherently calculate straight line paths, and only compute ray object intersections, the continuous, wave-like attributes of diffraction must be discretely approximated.
First, based on the analysis of the algebraic and geometric properties of cable tension constraints, we present the sufficient and necessary conditions for the end-effector to pass through parallel singularities along straight line paths.
Further, on average, one-year-olds that traveled with older birds strayed by 63.9 km from straight line paths, which was 33percentt less than for one-year-olds that traveled in same-age flight groups (see figure 3 at right; larger view).
b Apparent straight line paths of the exiting electrons traced back to the virtual image plane ( z=Delta f+4{L}_{mathrm{M}}/3, ) for defocus ( Delta f ) controlled by the magnetic part of the objective lens.
First, conditions for cable tensions to be positive along a straight line path are given geometrically.
Based on these findings, the authors predicted that flight groups where the oldest individual(s) had a migratory age of one year would stray from the straight line path by roughly 76.1 km, whereas flight groups where the oldest individual(s) was eight years old were predicted to deviate from the straight-line path by only 46.8 km.
Experimental results for straight line path following control are obtained for a physical USR, that enable a comparison of the USR motion with and without the passive caudal fin, both for lateral undulation and eel-like motion patterns.
This paper proposes an innovative cold orbital forging method for manufacturing gear rack, in which the complicated teeth of gear rack are forged by the highly dynamic rocking tool under straight line path.
Firstly, a universal method for designing the rocking tool under straight line path is proposed according to the forming mode and contacting mode between the rocking tool and component, i.e., one side of the component is ultimately overall formed by the overall contact (it is achieved by the incremental deformation) between the corresponding side of the rocking tool and component.
The position of the CM of the robot (blue) converges to and follows the desired straight line path (the x-axis).
Transmitting sources may be located by estimating the angles-of-arrival at a receiving array if the "direct path" is present, i.e., the straight line path between source and destination.
