Sentence examples for stick zone from inspiring English sources

The influence of the eccentricity of the stick zone on the fatigue failure is also discussed.

It is shown that only one stick zone exists within the contact region.

During fretting, the removal of material by wear leads to an increase of contact stress in the stick zone.

Furthermore, it is supposed that the contact patch is controlled by a central stick zone accompanied by two slip zones.

For a steady-squealing mode, the stick zone of the contact area is determined by a smooth friction velocity curve having both negative and positive slopes.

In this state, part of the contact area (the permanent stick zone) experiences no further slip, whereas other points may experience periods of stick, slip and/or separation.

The shear stress exerted along the sticking zone is found to be equal to the shear flow stress of the work-material.

The contact size, stick-zone size, indenter approach, Coulomb energy dissipation and surface hoop stresses are tracked during fretting.

An equation based on displacement continuity is derived to relate the stick-zone extents for any shear configuration; this equation is essential for the solution of general partial slip problems involving two stick-zones.

Viscoelasticity necessitates the application of the stick-zone boundary condition in convolved form, and also introduces additional convolved gap terms in the governing equations, which are not present in the elastic case.

Such categorization diagram is actually a sliding bifurcation diagram; crossing from one stick-slip zone to another corresponds to the triggering of a sliding bifurcation.