Sentence examples for step of calibration from inspiring English sources

The final step of calibration was the calculation of the friction correction parameters.

To adjust the deviations of the markers positions, two steps of calibration must be carried out: scaled (see Fig. 2a) and coordinate transformations (see Fig. 2c).

After applying the final step of the calibration process where the detectors were calibrated to each other, the average standard deviation is reduced to less than 1 × 10−2 for both amplitude and phase.

The next step of the calibration was measuring the inertia of the rotor.

The step of the calibration signal used by the SWCAL function is specified with following three parameters: (1) initial frequency, (2) number of steps, and (3) step mode (linear or exponential).

The calibration source count rate and the background count rate used to calculate the calibration factor were also evaluated separately using a mixed-effects model to estimate the influence of the previous listed effects on each step of the calibration factor calculation.

Fig. 2A shows the weight-to-deflection curve of the first step of the calibration for 19.1 mm-long wire, and Fig. 2B shows the force-to-output voltage curve for the whole wire calibration.

It includes an interface that shows each step of the calibration process to help you learn how to fine tune a plasma TV.

The results were compared with those of the step-by-step calibration to demonstrate the rationality and feasibility of the multi-objective approach.

The results of the step-by-step calibration fell in the dominated section for NH4-N improvement, where just the optimum of the runoff simulation was achieved with a large potential to improve NH4-N simulation without a significant degradation of the runoff simulation.

Key steps of the calibration procedure were further investigated and optimized to obtain adequate calibration curves.