In ICIM for additive QTL mapping, marker selection was performed just once using stepwise regression and considering all marker information simultaneously; this is a key step in determining the scanning profile.
An important step in the automated Scan-to-BIM procedure is the interpretation and classification of point cloud data.
With (lambda/2pigeq) 1 MHz, Rabi transfers between the transmon and nanoresonators would occur over a time-scale of at most 250 ns, which would set the minimum dwell time for each step in the flux scan to determine which nanoresonator mode is populated.
The first step in the embedding process (after scanning in sequential order) is to increase by 1, the value of pixels between 155 and 254 (including 155 and 254).
The first step in the protocol is to scan the unexposed pieces of film five times.
As a first step in proper US scanning, the sonographer must be aware of the circumstances of the injury, the patient's symptoms, and the clinical findings [31, 32].
As described in [17], when large CFO correction is required, a first step in the estimation process consists of scanning the subcarriers around the pilot subcarrier locations to determine the subcarrier with the highest energy.
All microstructural investigations were performed at a radius of 10 mm of the HPT sample after the first deformation step and at a radius of 3 mm after the second deformation step in the tangential direction with a scanning electron microscope (SEM) type LEO 1525 using backscattered electrons.
To save acquisition time, the step size in the (manually scanned) x direction was larger but still below the anticipated resolution limit.
[1] [4] These broadly fall into three classes, (i) special-purpose perturbation type approaches, also known as thermodynamic integration [5], (ii) step-by-step reconstruction methods, in particular the scanning procedures introduced by Meirovitch [6], [7], (iii) direct approaches which analyse information readily available in standard equilibrium simulation trajectories [8] [10].
