Sentence examples for steel sintering from inspiring English sources

In 1991, W Ni Mn alloys were identified and became the precursor to W Ni Cu Mn alloys that densify at 1200 °C, a temperature associated with steel sintering.

In order to better understand the environmental response of Chinese DFGD materials, this study compared the leaching characteristics of three typical DFGD materials produced from different flue gas sources (i.e., coal-fired boiler, iron and steel sintering plant, and circulating fluidized bed (CFB) boiler).

For all substrates, best results were achieved with suspensions of distilled water containing 20 wt.% Bioglass®, an applied voltage of 5 V and a deposition time of 5 min. For the stainless steel plates, sintering at 950 °C led to a complete covering of the plates with a continuous Bioglass® layer, assisted by viscous flow of the glass.

A novel catalyst support for volatile organic compound elimination stainless steel fiber sintered felt with honeycombed channels (SSFSFHC is prepared via solid phase vacuum sintering.

This kind of rough stainless steel fiber sintered felt (SSFSF) exhibits a higher inertial coefficient and high permeability compared with smooth SSFSF and foam materials.

In a steel-sintering plant a bed of powdered iron ore, mixed with coke or anthracite, is ignited by a gas burner and then moved along a traveling grate.

An iron and steel production whole process (ISPWP) with coking, sintering, iron-making, steel-making, continuous casting and steel-rolling procedures is considered in the paper.

The mechanical properties of these low-density materials are linked to their architecture (fiber orientation, number of contacts, etc).. Specimens can be produced with and without cross-links between fibers by sintering for steel wool or by using epoxy spraying for carbon or glass fibers.

The sintering parameters including sintering temperature, sintering time, sintering atmosphere and sintering position were discussed.

Sintering of steels containing oxidation sensitive elements is possible if such elements are alloyed with others which present lower affinity for oxygen.

Examples of this situation are sulfur recovery plants at petroleum refineries, coke oven batteries and sintering plants at steel mills, and chemical process plants at refineries.