Sentence examples for steady coefficient from inspiring English sources

We set a maximum steady coefficient of 1.8, which is the absolute maximum measured for birds under steady state conditions [58], but should not have been extraordinary for pterosaurs.

A new set of modified quasi-steady coefficients are suggested, where the experimental results of the aerodynamic derivatives are used to obtain frequency-independent model coefficients.

The critical velocities predicted by the modified quasi-steady coefficients differ only by 4 5% from estimates based on the aerodynamic derivatives.

The variations in steady state coefficient of friction with the changes in filler proportions and sliding test variables were small.

The steady resistance coefficient of nano-oxide thin films and free of contamination production process are probably important for eliminating current jitter.

It was also found that the B4C/a-C coating with B 2.92 at.% exhibited the lowest steady friction coefficient about 0.05 and highest wear resistance at 20% RH.

Lower and steady friction coefficient and higher wear resistance for both the coating and the steel ball were achieved at higher relative humidity.

The duplex coating exhibits best antifriction property, registering a lower and steady friction coefficient of ≈0.12 than that of the polished microarc oxidation coating sliding in the similar condition.

Results showed that round depressions with diameters of 10 μm had a significantly lower steady state coefficient of friction than the non-patterned substrates or substrates with greater diameter depression patterns.

While sliding against 100Cr6 steel balls, the steady state coefficient of friction (CoF) increased with increasing surface roughness of the coatings, but the CoF remained unaffected in the case of comparatively harder Si3N4 balls.

While the recorded steady state coefficient of friction (COF) does not show any noticeable difference (varying in the range of 0.6 0.7) with respect to difference in warm rolling conditions, the fretting wear rate (10 26 × 10− 5 mm3 N− 1m− 1) of the steel backed and warm rolled strips exhibits a systematic decrease in wear rate with increase in amount of warm rolling.