Factors of age, bacteriologic status, tooth position and type of filling material showed no clear effect upon post-operative results.
Serial measurements of BNP drawn on up to three consecutive days showed poor correlation with changes in invasive measures of filling pressures and net 24-hour fluid status.
There is potential for misclassification of exposure status through lack of consumption of filled prescriptions.
As the E/A ratio is load dependent and thus influenced by the filling status of the patient, an estimation of LV filling pressure was determined (E/Ea) (Paelinck et al, 2005), which did not change after chemotherapy.
Kind of filled with ghosts.
Since that frame has been designed to provide two positions separated by a dividing plate and the HCLL-TBM is expected to fill one of them, its nuclear response could vary depending on the filling status of the other position and on the plate thickness.
In particular, since that frame has been designed to provide two cavities separated by a dividing plate and HCLL-TBM is foreseen to fill just one of them, its nuclear response could vary accordingly to the filling status of the other one, unless the dividing plate is thick enough to isolate the components housed in the two cavities, avoiding any significant nuclear interaction among them.
For example, in a hypotensive or shocked patient the estimate of the filling status and of the response to fluid challenge are crucial information, usually unavailable without invasive techniques.
Another topic on which ultrasound can supply crucial information with a startlingly simple technique is the filling status of the patient.
Monoplane hemodynamic transesophageal echocardiography (hTEE; ImaCor, Inc., Garden City, NY) is a relatively new diagnostic tool, allowing the intensivist to directly assess both the contractility and filling status of both the right and left ventricles at the bedside in real-time.
From experiments, it was found out that filling status of the hollow gear was improved in comparison with that of the solid gear irrespective of forming conditions and the predicted forming load obtained from the developed design system matched well with the experimental load requirements.
