Sentence examples for static total from inspiring English sources
The Brillouin zone (BZ) is represented by a set of 6 × 6 × 1 k-points[32] for geometry optimization and for static total energy calculations.
To calculate the nucleation behavior, information about bulk thermodynamics (both static total energies and vibrational free energies), interfacial energetics and coherency strain is required.
The RE solubilities in Al are calculated, including both static total energy contributions as well as the free energies associated with atomic vibrations.
On the other hand, neurofibrillary tangles and neurodegeneration are believed to be downstream pathological events that progressively worsen in the presence of a relatively static total load of amyloid and which lead directly to cognitive impairment (Ingelsson et al., 2004; Jack et al., 2010).
Each negative feedback loop is modelled using a Hill function; Ot is the static total operon concentration; k1, k2, k3 represent transcription rate, translation rate and tryptophan synthesis rate, respectively; kd1, kd2, kd3 are the degradation rates (aggregated parameters combining the decay rate and dilution rate due to cell growth).
Static and total pressures of the airflow are input quantities for the isentropic equation used for Mach number estimation.
The static and total pressure drops under forward flow direction are larger than those under reverse direction in both single-phase flow and two-phase flow.
The effect of scale of the static mixer, total flow rate, flow ratio between the fluid streams and inlet configuration have been investigated.
This paper presents an assessment procedure whereby only critical loading events are considered to allow for an efficient and accurate determination of independent values for characteristic (lifetime-maximum) static and total (including dynamic interaction) load effects.
Dynamic, static, and total β-cell responsivity (Φd, Φs, and Φtot, respectively) and Si were assessed by oral C-peptide and glucose minimal models.
The basal, dynamic, static, and total disposition indexes (DIb, DId, DIs, and DIoral, respectively), representing β-cell function adjusted to IS, were calculated by multiplying β-cell responsivity indices by IS.
