Sentence examples for stated that the maximum from inspiring English sources

The experimental design stated that the maximum adsorption capacity was reached when the initial concentration was 6400 mg/L and the solid-liquid ratio was 10 g/L.

The plan's terms stated that the maximum award to any participant for a performance period could not exceed eight times that person's annual base salary, or $50 million, whichever came first.

That year, Claude E. Shannon of Bell Labs stated that the maximum amount of data that can be transmitted through any channel is limited by the available bandwidth (the amount of radio-frequency spectrum it occupies) and by its signal-to-noise ratio (the signal to be communicated versus interference).

In the preceding paper it was stated that the maximum current is a manifestation of electrochemical and hydrodynamical instability, originated by incessant and random imposition of perturbation about the surface of the electrode; and that the conditions when the maximum current occurs can be obtained theoretically.

In terms of the values of the nuclear points needed to define the bond slip relationship, it can be stated that the maximum bond stress determined from the NSM samples approximately reached 20.0 MPa.

FIFA technicians stated that the maximum capacity of the current structure would be 46,000 spectatorsbelow the FIFA minimum of 60,000.

Brewster's law, relationship for light waves stating that the maximum polarization (vibration in one plane only) of a ray of light may be achieved by letting the ray fall on a surface of a transparent medium in such a way that the refracted ray makes an angle of 90° with the reflected ray.

According to the results of Theorem 4 represented in Fig. 11 and [26], we can state that the maximum possible power efficiency, avoiding PA saturation, is achieved when peak power of the amplified signal coincides with the saturation power.

Using a report [23] stating that the maximum occlusal force applied to an implant superstructure in the molar region is 200 N as a reference, we selected 100 N for loading, to simulate the forces generated during mastication.

They said this was a breach of article 5.5.3 of the technical regulations, which states that the "maximum accelerator travel position must correspond to an engine torque demand equal to or greater than the maximum engine torque at the measured engine speed".

For all the charts shown in this section, we can state that the maximum error for all the values represented (mean values) is below 5%, with a degree of confidence of 95%. Figure 10 shows the overhead introduced by HOP compared to the default HIP implementation as we increase the hop count between the source and destination terminals.