Sentence examples for standardised error from inspiring English sources

Comparison of the relative bias of the I component estimate for the averaged Monte Carlo simulation results and the approximate analytic results plotted over the CNR. Figure 3 shows the standard deviation of the standardised error x ̂ − x r of the estimation of the I component x.

All application errors are recorded (eg, failure to post to a feed) to a standardised error log, as is downtime of the application and of Facebook itself.

Further, diagnostic error incident reports from providers are not included in the standardised error reporting protocols in the common formats developed by the Agency for Healthcare Research and Quality.

They used the QOLIE-89, which is similar to the QOLIE-31, and found an initial value of 52.5 ± 1.3 (standardised error margin) and two years later a change of 2.3 ± 7.0 in the IG and 1.5 ± 7.2 for the CG, which is not clinically significant, according to Wiebe et al., who established an MIC of 10.1 points for the QOLIE-89 [ 39].

The convergent validity is evaluated using the average variance extracted: AVE = (∑λ i )/(∑λ i ) + (∑v [δ i ]); where λ i = completely standardised factor loading for item i; ∑v [δ i ] = completely standardised error variance for item i. *) Passive behaviour: the scale values were reversed so that high scores reflect high levels of health motivation.

The Bayesian model was assessed using the Q-Q plots of standardised predictive errors (SPE).

To accelerate the bMRI reading workflow and reduce potential sources of error, a standardised hanging protocol or layout is recommended.

The results showed that using a standardised protocol minimises measurement error, enabling reliable measures of performance.

Using a standardised measurement protocol, the error of measurement was found to be less than 3.5° between different testers and less than 1.7° when repeated measurements were repeated by the same tester.

First-order factor correlations, standardised factor loadings, standard error, and squared standardised factor loadings for the observed variables and latent constructs are summarised in Table 2. Correlations between the first-order factors (three subscales) were above 0.70 (Table 2), indicating that there was a degree of overlap between the factors.

The standardised factor loadings and errors are reported in Table 8 for the measurement model depicting the original factor structure of the WHOQOL-OLD.