Sentence examples for standard tolerances from inspiring English sources

Recommendations for the acceptance of weld undercuts and comparison with current standard tolerances were discussed.

These indices are compared with the conventional topology with respect to standard tolerances.

For bearings of standard tolerances these deviations are large enough to cause measurable levels of vibrations when the bearing is in operation.

This is because the values of machine component and tool holder deflection were lower than standard tolerances (10 μm) and found to be lower than 1/15 of tool deflection.

The results of the experiment indicate that although the AR approach is less precise, it can satisfy standard tolerances, and the simpler and faster setup may compensate for its shortcomings.

There is a necessity for developing a complete answer representing standard tolerance practices.

BS EN 20286 Part 2 provides tables of standard tolerance grades and limit deviations for holes and shafts.

Standard tolerance limits will accelerate the process of design (Wadsworth et al. 2002).

In these calculations we set (N=2^{9}) and used Matlab's in-built ode45 routine, with standard tolerance settings.

Standard tolerance limits can be obtained through conducting statistical calculations based on one or more samples of an assumed quality characteristic.

The reliable scale as defined by Elder and Zucker, means that at the selected scale and larger ones, the likelihood of error due to sensor noise is below a standard tolerance.