Sentence examples for standard span from inspiring English sources

The standard span of 80 or so years suddenly seemed woefully inadequate.

Closer area to abutment 2 is a voided slab with standard span of 40 m, cross section 2 m deep, and maximum width of 35,85 m.

75 km straddle monorail line in Chongqing line 2 has been completed, and most of them use PC simply supported beam in standard span of 22 24 m, so that the project was implemented with advantages of easy, reasonable cost, convincible line maintenance, etc.

For both the shotgun proteomes and transcriptomes, replicate datasets were fitted with a locally weighted scatterplot smoothing by polynomial regression using a standard span value of 0.75 (R Core Development Team, 2014), using the replicates of unprocessed samples, and the replicate time series of 7.8 72 hr, as input for the regression.

HURP protocol builds automatically a core with the interconnected HURP routing bridges and the standard bridges get connected to the edges in standard spanning trees.

Given standard spans are usually smaller than 100 m, special spans can be divided into two categories by the length of main span: medium length (100 200 m) and large length (200 500 m).

Different concentrations of standard, spanning from 0,114 ng/µl (0,5 µM) to 1,14 ngµl (5 µM) of 5-Aza-2-dC, were prepared and the peak area of each 10 µl sample was calculated by HPLC.

This basic information includes the following: beam type (standard name or non-standard), span length (measured center to center of bearing), beam spacing, slab thickness, composite slab width, live load distribution factor, relative humidity, uniform dead load on composite section due to overlay and the uniform dead load on composite section excluding overlay.

Table 1 reviews the transmit waveform specified by existing mobile system standards, spanning 2G to 5G communication systems.

Acid-stabilized filtered samples were analyzed by ICP-MS, using Dy as an internal standard, and calibrated against U standards spanning the experimental concentration range.

It can be demonstrated that by enforcing a planar network topology combined with the requirement of minimum-pathloss between connections, one can achieve a gain in signal-to-noise and interference ratio (SNIR) by a few decibels with respect to standards spanning methods.