Sentence examples for spread simulation from inspiring English sources
Disaster spread simulation and rescue time analysis in resource networks are key problems in disaster prevention and relief.
Results show that for each of the three fire spread patterns, some landscape factors exert a higher influence on fire spread simulation than others.
"Applying fire spread simulation over two study sites in California lessons learned and future plans", with Alan Forghani* & Bob Cechet, Mark Finney & Bret Butler, Geoscience and Remote Sensing Symposium, 2007.
Figure 4 Comparison of delay spread simulation results with measurements in warehouse scenario.
In addition, the stagnant population of poultry and the lack of attributes for different types of poultry farms could make the model limited when used for generalized AI spread simulation.
As for the model verification, fire spread simulations were carried out in a hypothetical urban area, where 2500 buildings of identical configuration were aligned at constant separations.
The performance of the implemented fire model is evaluated by comparison with fire spread simulations derived from Prometheus, the national Canadian fire behaviour modelling tool based on elliptical wave propagation principles.
The results show that including scattering does not improve significantly the prediction accuracy, except in the last three positions, which can described as deep NLOS, where RT without scattering fails to predict any ray, or a significant number of rays, arriving at the Rx. Figure 6 Comparison of delay spread simulations results with measurements in office scenario.
During the spreading simulation, the cables and struts were depicted as truss elements that only supported axial force and deformation.
The spreading simulation of the OT structure was restricted at the extreme spreading area (274µm2, supplementary Fig. S2) that was still much smaller than the spreading area in living cells [27], [28].
The energy curves of cables and struts overlapped between two types of spreading deformations (between the dash vertical lines in Figs.5A and 5B) and indicated an optimized result for different FA numbers in the spreading simulation of the COT structure.
