Sentence examples for split of liquid from inspiring English sources
Chocolate and cream are best mixed quickly and lightly, to help avoid the dreaded split of liquid and fat.
A comprehensive model which incorporates the important phenomena in the flow of gas and scrubbing liquid through venturis is shown to predict reasonably the split of liquid between drops and film on the venturi walls.
The effects of important design parameters including gas composition (CO2 CH4), split ratio of liquid, the fraction of CO2 removal at the middle and exit of stage (xM, xexit), liquid temperature and number of stage on required contact area are also investigated.
The main flow parameters which can be measured with the present experimental set-up are the circumferential distribution of the film height, flow rate and tracer concentration, the rates of droplet entrainment and deposition and the split of the liquid phase between the wall layer and the entrained droplets.
In this study, the effects of liquid split and vapor split ratios on the energy efficiency and controllability of a divided wall column system for separating ethanol, n-propanol, and n-butanol were investigated.
An open trench runs parallel to this road, snaking through the neighborhood until it splits into tributaries of liquid filth, some of which must be crossed on rickety planks.
Pressure drop of the ICH is much lower than that of the typical hydrocyclone; and the ICH has a wider scope for the change of liquid split ratio or inlet gas liquid ratio.
Don't forget that this number can be split between different types of liquid.
The new principle of operation allows reproducible splitting of a stream of liquid into multiple flow channels.
All patients received low volume (2 l) PEG-ELS with sodium ascorbate and ascorbic acid (MoviPrep) administered as a PM/AM split dose, with 400 mg of liquid simethicone added to each dose of purgative in the PEG-S group.
The effects of cycle period, cycle split, and liquid flow rate on SO2 removal in a periodically operated trickle bed of activated carbon were investigated using a simulated flue gas containing 2500 ppm SO2.
