Sentence examples for speed of lifting from inspiring English sources

Difficult issues include Iran's insistence on pursuing advanced centrifuge research, Tehran's need to answer questions on past nuclear activities that could be arms-related, and the speed of lifting sanctions.

Among questions facing negotiators as they seek to prepare a resolution for the Security Council is the timing and speed of lifting U.N. nuclear sanctions, including whether to present it in March if a political framework agreement is signed next week or to delay until a final deal is reached by the end-June target.

To investigate the effects of lifting speed on the performance of electrochromic device, lifting speeds of 1000, 2000, and 3000 μm/s were used by fixing the TiO2 nanoparticle size of 5~10 nm, the precursor concentration to be 1 2, and the dipping number to be 1.

The improved cycling stability owes to the decreased roughness of deposited TiO2 thin film with the increase of lifting speed, as illustrated in Fig. 4a.

The decrement rate of optical transmittance contrast after 1500 cycles is measured to be 27, 36, and 40% for modified devices prepared with lifting speed of 3000 μm/s (Fig. 5a), 2000 μm/s (Fig. 10a), and 1000 μm/s (Fig. 10b), respectively, indicating ~33% improvement with the increase of lifting speed.

Under these conditions, it was found that O2 a1Δg) enhanced the propagation speed of C2H4 lifted flames.

The effect is the same as with an aircraft changing the pitch of the ram-air "wing" converts much of the forward speed to lift and thus minimizes forward and downward velocities at the time of ground contact.

I was 12 and I remembered the thrill of lifting up into the air with such speed.

Transmittance spectra of modified devices prepared with different fabrication conditions, including a lifting speed of 2000 μm/s, b lifting speed of 1000 μm/s, c precursor concentration of 1 3, d precursor concentration of 1 4, e dipping number of 3, and f dipping number of 5.

Reflectance spectra of modified devices prepared with different fabrication conditions, including (a) lifting speed of 2000 μm/s, (b) lifting speed of 1000 μm/s, (c) precursor concentration of 1 3, (d) precursor concentration of 1 4, (e) dipping number of 3, and (f) dipping number of 5. Table S1.

The representative edge propagation speed of a single lifted flame or an upstream lifted flame in the case of twin lifted flames increased as the liftoff height became higher.