Sentence examples for speed injection from inspiring English sources

Momentum transfer, heat transfer and reaction behavior inside the riser were discussed in detail and inhomogeneity in these aspects were observed especially above the high speed injection nozzles.

In the present study we emphasize that the measured results are significant for the design and simulation of ultra high speed injection processes such as micromolding and thin-walled injection molding.

Determination of the rheological behavior of a polymer melt under high shear rate is generally considered to be crucial for accurate simulation modeling of ultra high speed injection molding, a process that has been attracting more attention from researchers.

Then the restriction is collated to the results of multivariable survey to find the most advantageous pellet speed, injection angle, and pellet mass which is consistent with both output control and tokamak geometry.

The influence of the speed injection parameters in the first and second phases and of the upset pressure over the die casting parts quality, in 305 aluminum alloys is investigated.

In addition, the injection molding of the product includes 24 mm of shot stroke, 1.47 mm position transfer, 268 rpm screw speed, injection speed 100 mm/s, 172 ton clamping force, 800 kgf holding pressure, 0.9��s holding time and 1.4 s cooling time, make the products in the shape and proportion of the product satisfactory.

To obtain a reasonable signal-time curve with a modest amount of contrast agent, high speed injections with a saline flush technique are preferable to acquire good quality signal-time curves (e.g. ∼40-50 ml of contrast agent injected at a flow rate of about 5-8 ml/s).

As an important safety feature for providing a high-speed injection flow to the core by compressed nitrogen gas pressure during a loss-of-coolant accident (LOCA), the accumulator injects its precharged nitrogen into the system after its coolant has been emptied.

An analysis of the speed of injection used in the previous studies suggests that a rapid speed of nicotine injection, which mimic kinetics of nicotine delivery with tobacco smoking [38] may have been critical.

We used a high speed of injection (200 msec), previously shown to facilitate nicotine self-administration and the volume of each injection was 0.2 ml for the 10 µg/kg/injection dose of nicotine.

Next, multivariable parameter dependence survey of the fuel deposition source on pellet speed, poloidal injection angle, pellet mass and pedestal height is performed.