Sentence examples for specimens with initial from inspiring English sources

Specimens with initial moisture contents of 5, 10, 15, 20, 25  and 30%% were prepared for Q2 loess and Q1 loess repectively to do the laboratory tests.

In this work, the fracture behavior of a dissimilar metal welded joint has been studied through testing of single-edged notched bend type of specimens with initial cracks machined at different locations.

This study performed and analysed quasi-brittle fracture of 0.1 m SS specimens with initial notch a0 from 1 to 25 mm for determination of tensile strength ft and fracture toughness KIC, from which fracture of 2 m LL beams with a0 of 250 mm was accurately predicted.

Common optical methods are not suitable for accurate measurement of elastic modulus of specimens with initial bending because it is rather difficult to separate the axial strain caused by the axial load from the surface strain which consists of the axial strain and the bending strain caused by additional bending moment.

The experimental results show good agreement between elastic modulus obtained using the proposed method and a strain gauge and the relative error between them is less than 0.5%, which shows excellent performance of the proposed method on accurate measurement of elastic modulus of specimens with initial bending.

It has been reported that specimens with initial high tensile bond strength as measured using a microtensile test degraded after 1 3 years [ 20, 21].

Inspired by the strain-gauge technique, averaging the two strains on the opposite surfaces can eliminate the effect of bending strain of the specimen with initial bending, which is easily implemented by dual-reflector imaging and two-dimensional digital image correlation (2D-DIC).

In particular strain field comparisons were made on specimens prepared: with initial constant stress intensity fatigue; with this initial fatigue followed by a single overload cycle; and with this fatigue-overload sequence followed by an additional constant stress intensity fatigue.

The yield stress of polypropylene specimens with different initial microstructural states is investigated.

Using this model, surface fatigue crack propagations in specimens with different initial shapes are predicted through detailed finite element simulations.

The constraint effect was evaluated by means of specimens with different initial crack lengths and the T-stress constraint parameter was used to derive constraint modified R-curves.