Sentence examples for specimens which increases from inspiring English sources

The results obtained to date are in full agreement with the expected data for the utilized specimens, which increases the confidence in the use of the device and the continuous work towards automation of fatigue experimental procedures.

Narrow field angle scanning is restricted to the numerical aperture or cone angle of the laser beam probing the specimen which increases the error in determining the three-dimensional properties of a specimen.

The heterogeneity of the specimens, which is increased by an internal reinforcement or by a basalt mesh, converts the blast damage due to internal rebounds into layer delamination.

The sulphates migration effect was confirmed and further investigated through the FTIR-ATR spectra on the inked surface of parchment specimens, which show increased presence of calcium sulphate in ink-free areas with ageing times.

Their suggestions have not been taken seriously by palaeontologists, as their evidence was largely based on misunderstandings of geology, and they never discussed the other feather-bearing specimens, which have increased in number since then.

The clinical relevance of these findings was confirmed in matched primary and metastatic human HNSCC specimens, which exhibited increased levels of ADAM17 expression and concomitant CD44 cleavage compared to controls.

Expanded resources for specimen testing are provided, which increases the likelihood of a pathogen-specific diagnosis.

Presumably low strain rates allow time for microcracking to develop, which increases the compliance of the specimen, making them tougher.

The rationale is the withdrawing stylet produces a low level of negative pressure within the needle which increases tissue acquisition and limits specimen bloodiness.

Competitively grown specimens are therefore often hand-pollinated to maximize the number of seeds in the fruit, which increases the fruit size; this pollination requires skilled technique.

The specimen was assembled using unpropped construction methods and had a degree of shear connection equal to 33%, significantly lower than the minimum required amount specified in Eurocode 4. A uniformly distributed load was applied to the specimen, which was increased until the failure occurred characterized by yielding of the steel beam.