Sentence examples for specimens to reduce from inspiring English sources

Scaling, a common Procrustes procedure, was not applied to specimens, to reduce the effect of inducing covariances through Procrustes fitting.

However, it is important to standardize the procedure in liquid media inoculated with clinical specimens to reduce the time to diagnosis.

For example, Koga et al (2010) used immunomagnetic beads conjugated with EpCAM monoclonal antibody to isolate colonocytes from stool, rather than performing colonocytes scrapping from the stool mucinous layer; several other studies used homogenised stool specimens to reduce selection bias.

Pretreatment of specimens to reduce viral load (i.e., with heat inactivation or polyethylene glycol) will be recommended in future cases, even though such treatment may affect laboratory results (9, 18 ).

The modified base plate was made such that the HCT is at the bottom of the specimen to reduce evaporation effect on the HCT and also to ensure a good contact condition between the HCT and the soil specimen.

This was carried out by introducing lateral side U-shaped and V-shaped grooves in the standard M T) specimen to reduce the size of the plane stress surface regions.

Adjuvant treatments were considered only in low-grade chondrosarcoma, giant cell tumors, chondroma and chondromixoid fibroma with liquid nitrogen (because absolute certainty of benignity of the lesion can only be assessed based on the entire specimen) to reduce the risk of local recurrence, improving the results of curettage alone [1, 4].

For isotopic analyses, we first ground off a portion of the surface layer of each shell specimen to reduce possible contamination.

Changing only a small volume of water at a time was therefore found to prevent exaggerated aggressive interactions among P. scalare specimens and to reduce the probability of injuries, stress, and detrimental impacts on fish welfare.

Further exclusion criteria were known genetic defects of the baby (e.g. Down's syndrome, Spina Bifida) due to the requirement for diagnostic placental specimens and to reduce maternal distress.

The 3-D models incorporate the full geometry of a pull-plate specimen designed to reduce the cost of testing full connections while retaining essential features of the fracture prone, weld region.