Sentence examples for specimens the values from inspiring English sources

The I B for sand is nearly 0.78 but for 10, 20 and 30% silt content specimens the values were below 0.5.

Fig. 22 Critical angles of the specimens: The values obtained with strain approach were higher compared to those obtained with FKM approach.

In artificially demineralized specimens, the values of the demineralized fields were subtracted from those obtained for the particular effect fields (E1 and E2 in Figure 3).

In the case of type B specimens, the value of P yield,S&T corresponds to the yielding of the tie between the nodes 5 and 8 and its symmetrical counterpart (the tie between the nodes 10 and 14), see Fig. 3b.

From Fig. 7 it can be observed that for STC specimen the value of CTODc depends on distributed-load width and the value of CTODc shows maximum deviation for STC specimen having β = 0 from those obtained for TPBT for a given specimen size.

In case of a cube-split tension test specimen the value of the length/characteristic dimension (l/D) ratio is taken to be 1 for which Ince (2012) derived the four term universal weight function using boundary element method and finite element method.

In the same specimen, the value of 3-glyceraldehyde-phosphate dehydrogenase (GAPDH) was also detected to calibrate the concentration of each target protein.

It is found that within the elastic range of the steel specimen, the average value, RMS value, counts value, peak value, and peak width ratio value decrease with increasing temperature.

In order to compare the levels of antibodies eluted from different lung specimens, the OD values generated for IgG binding to candidate lung antigens were standardized by expressing them as ratios to the OD values of the same eluates for binding to the negative control antigen, thyroglobulin.

For the as-cast specimens the hardness values increased from 133 to 188 Vickers (10 kg) with an increase in SiCp content from 0 to 30 wt% and for the heat treated specimens the hardnes values increased from 171 to 221 Vickers (10 kg).

It predicts the permeability of a randomly oriented spherulitic diblock specimen from the values of the permeability coefficients of the individual lamellar regions of the copolymer.