One interesting point is that, for the unequally notched specimen, the difference between the crack tip triaxial stress for tension and that for bending increases significantly with the increase in the back angle.
The flexural toughness of SFRC specimens is greater than that of CC specimens with the difference being significantly larger for over-reinforced sections.
Conversely, T5 specimens were smaller than C. t. toxostoma specimens and the difference in weight between the two was smaller than that for H5 and C. n. nasus.
There was no significant difference in seroprevalence between regions in pre-pandemic specimens, but the difference in pH1N1 seroprevalence between pre- and post-pandemic specimens was significantly higher in Sydney than in the rest of NSW (19.3% vs 9.6%, Table 2).
Both total and free chloride content reduced with depth into the specimens and the difference between chemical total and free chloride content was found to be in the range of 5 65%, depending on the depth in the specimen.
A comparison of the ultimate capacity of the CFPFBs with and without stiffener reveals that the FE models simulate very well the flexural behavior of the test specimens and the difference of maximum load is found to be less than 10%.
High ROS1 copy number was rarely detected in tumor specimens and the difference in ROS1 copy numbers between tumors and CTCs observed here cannot be merely explained by the different nature of samples (paraffin tissue section versus whole cells).
A probe was considered hypermethylated in a UC specimen when the difference between the β-value of the tumor and the mean β-value of the NU samples was greater or equal to 0.2.
ΔCt was calculated for each subject specimen as the difference between Ct values of each target gene of interest and the GAPDH gene and averaged, and higher mean ΔCt values represent less gene expression.
