Sentence examples for specimens the change from inspiring English sources

However, due to the large slenderness ratio of the test specimens, the change of compressive strength of concrete core did not show significant effect on the critical axial compressive capacity of concrete filled columns although the axial compressive capacity increased with the concrete grade increase.

Twin boundary reorientation and de-twinning occurred in the prestrained specimens, and the change in the fraction of 90° twin boundaries by the prestrain was similar to that of the reverse phase transformation IF.

In the IR spectra of the two latter specimens this change was accompanied by a splitting of the β-sheet sub-band in two overlapped components (plateau 1633 1620 cm−1) at 1633 cm−1 (intramolecular β-sheet) and 1620 cm−1 (intermolecular β-sheet) as it can be seen in the EG@Mr spectrum shown in Fig. 8a.

The average changes in the mass of concrete specimens representing the changes in the bulk density and eventually changes in porosity are presented in Table 3.

The dial gauge was then installed on top of the specimen to measure the change in the length of the specimen.

The reduction in the pore-water pressure after the peak indicates that the specimens change from contractive to dilative behavior during shear, as illustrated by the effective stress paths shown in Fig. 17.

The reduction in the excess pore-water pressure after the peak indicates that the specimens change from contractive to dilative behavior during shear, as illustrated by the effective stress paths shown in Fig. 11.

Moreover, the addition of L-shaped laminates enhanced the shear capacity of the specimens and changed the failure mode from brittle to ductile under static loading.

As shown in Fig. 7a, the hydrogen thermal desorption behaviors of the immersed specimens were different according to the specimen microstructures, which implies that the hydrogen state in the immersed specimens can change with the specimen microstructure.

For the lightly exfoliated specimen, the UIT changed the crack nucleating mechanism from intergranular cracking in exfoliation to fretting in the grips, which then resulted in a much longer fatigue life.

Yet these specimens still change the exit wave because electrons interact with the material.