Sentence examples for specimens tested and from inspiring English sources

Experimental results showed that it was feasible to describe monotonic and cyclic tests of stress-controlled mode using one single damage accumulation model based on stress time path, which makes it possible to reduce the number of specimens tested and time-consuming fatigue tests are no longer necessary, since the same information can be obtained from monotonic test data without loss of accuracy.

While both bonded VHB™ Tape and structural silicone specimens exhibited some voids, there was less sensitivity of time to failure to the voids and defects seen in the VHB™ Tape specimens tested and significantly less scatter in the time to failure data than specimens made with the structural silicones.

A rigorous uniaxial finite element model was first validated against experimental results, and then used to predict the total deflection at the end of the 50-year service life of the specimens tested and of other specimens with different connection system not tested.

The results obtained demonstrate that the surface hardness of AISI D2 steel undergoing ion nitriding and atomic attrition was about 1500 HV; which is the highest surface hardness among all the specimens tested, and almost 250 HV higher than that of a conventionally ion nitrided specimen.

CDC Virus Surveillance consists of about 140 laboratories located throughout the United States that report the weekly total specimens tested and laboratory tests positive for influenza virus [10].

The specimens tested, and the frequencies to which they were subjected, are shown in Table 1.

The overall trend has been the low dissemination in the populations of Ae. aegypti from Dakar (6.3%% of the 111 specimen tested), Ae. aegypti from Kedougou (5.6 % of the 216 specimen tested) and Ae. unilineatus (5.3 % of the 56 specimen tested) and a relatively high dissemination rates in Ae. vittatus (27.0 % of the 37 specimen tested) and Ae. luteocephalus (42.2 % of the 45 specimen tested).

When comparing two methods, overall percent agreement was calculated from the number of specimens tested positive and negative by both methods, and the total number of specimens.

This work extends the testing presented in Wormsen et al. (2015a, 2015b, 2015c), covering fatigue testing of smooth and notched low alloy steel specimens tested in-air and smooth specimens tested in 3.5% NaCl with CP.

The fractography of the CNT specimens tested at Ecorr and Ea p presented evidence of SCC.

Specimens tested under bending and diagonal compression were retested after repair with injection of mud grouts.