Sentence examples for specimens shown in from inspiring English sources

In this section, using ANSYS and VecTor2 programs, the five specimens shown in Table 1 are analyzed.

Table 2 shows test specimens used to compare calculated strengths; all test specimens shown in Table 2 have the same dimensions, except for E-FBP (Lee 2005).

However, it should be noted that the specimens shown in Figure 5c,e,f,f was fabricated using the asher process to remove the polymeric passivation layer.

To make DCB specimens shown in Figure 1, two large GFRTP plates, whose size is 180 × 200 mm2, were bonded and cut into the specimens.

The values of cohesive toughness for STC and TPBT specimens shown in Fig. 9 also show that these values either obtained using STC specimen or TPBT specimen are in consistent with each other.

To interpret these apparently contradicting results, it must be noted that the total exposure time of the specimens in Fig. 19a was 108 weeks, i.e. near double the exposure time of those specimens shown in Fig. 19b.

The egg oil emulsion specimens showed, in general, a more irregular surface than that of the egg tempera paint films as can be seen in Fig. 5a.

The modern human specimen shown in Fig. 1e derives from the collections described in ref. 4. The age at death of this specimen was 5.3 years old and had only the deciduous dentition erupted.

The same pattern was observed in the HP2F1 specimen shown in Fig. 6b.

Figure 3e shows the enlarged top-view SEM image of the nanosheet on the specimen shown in Figure 3c.

The NP2F1 specimen shown in Fig. 9d exhibited significant differences between the crack openings and crack slips.