Sentence examples for specimens is set from inspiring English sources

If the rolling time to mold rutting specimens is set at 12 round-trips, the temperature must be controlled at 180 190 °C to meet technical standards (DS ≥ 3,500 times mm−1).

Y-TZP is a biocompatible material already approved for clinical applications, and herein, Y-TZP specimens were set up as the control group.

The environmental conditions ideal to the reproduction and control of these specimens were set up: temperature at 20°C, moisture around 60 85%, aeration conditions and darkness.

The specimens were set in an intertidal environment and divided into two study groups: one whose bacterial film was removed, and the other whose bacterial film was left intact.

This specimen was used for tear resistance test measurements with a 1 mm nick at point A. The specimens were set up to have the force applied vertically by an Instron 3369 tensile testing machine with a 1 kN load cell (Additional file 1: Figure S1 (Appendix)), at a crosshead displacement speed of 500 mm/min.

Specimens were set aside until a clot formed (generally 5 min).

The cylindrical axis of the specimen is set parallel to that of the glass tube, which is also fixed along the spinning axis by using a collet.

One specimen is set up to be hammer impacted on the mid-span section of the top chord between two K-joints, while another is loaded on the mid-span section of the top chord within the middle K-joint.

The specimen was set aside because few H1N1 cases were reported last winter, and the centers routinely concentrate on testing the most prevalent strains.

A finite element model of the notched specimen was set up for the analysis of the stress field acting during fatigue loading; this allowed a prediction of its fatigue behaviour, which appeared to be in satisfactory agreement with experimental observations.

Although the pre-crack length of the specimen was set to 50 mm to insert the PTFE sheet, an initial crack front is not sufficiently sharp, and overestimation of the G IC value is expected at the first part of the crack propagation.