Sentence examples for specimens involves both from inspiring English sources
Studies of beam-induced motion have shown that the observed motion in cryo-EM specimens involves both the ice and the carbon support (Glaser et al., 2011; Brilot et al., 2012).
The analysis of the specimens involves the following bone measurements: bone volume fraction (BV/TV, %), trabecular number (Tb. N), trabecular thickness (Tb. Th), trabecular spacing (Tb. Sp), and cortical thickness (Cort.Th).
The usual laboratory procedure for clinical specimens involves microscopic examination for the presence of AFB and isolation and identification of the organism by culture.
Conventional pathologic examination of gross liver specimens involves slicing the organ at 1 cm intervals, but then employing the same methods as those used by the surgeons at laparotomy visual inspection, and palpation.
Our method for constructing TMAs from these specimens involves cutting out small 4 mm lengths of the biopsy specimen and repositioning them in a vertical orientation so that approximately 90 100 4- μm-thick sections from each biopsy can be made available for IHC staining, in comparison to only a few from the original horizontally embedded specimens.
The specimens involved two sections and seven slenderness ratios varying from 15 to 100.
Six specimens involving two different connection types subjected to monotonically increasing bending action are examined.
In this study, 120 single shear bolted connection specimens involving three different thicknesses of thin sheet steels and 30 coupon specimens were conducted by using steady state test method in the temperature range from 22 to 900 °C.
In this study, 100 single shear bolted connection specimens and 22 coupon specimens involving three different grades of stainless steel were conducted by using steady state test method in the temperature ranged from 200 to 950 °C.
Model sandwich specimens involving a compliant polymer core sandwiched between two metal layers were designed and subjected to impact loading to simulate failure evolution mechanisms in real sandwich structures.
The manufacturing route adopted for the auxetic PU specimens involved a multiaxial compression of the native foam, heating of the compressed specimens above the Tg of the foam polymer, and cooling under running water.
