Sentence examples for specimens in spite from inspiring English sources

Branching occurs frequently in PLA specimens but not in wood fibre composite specimens, in spite of high energy release rates.

For those untransformed α grains in the SSPTZ-2 of both specimens, in spite of maintained bulk morphologies, slight subdivisions by subgrains are found inside them due to extensive dislocation activities induced by transformation stresses and/or their recovery.

The situation in the blood compartment is more complicated because LOS levels were detectable in only 1/4 of the specimens, in spite of a significantly stimulated immune response.

This method may make it possible to accurately analyze gene expressions in cancer cells from a small amount of a biopsy specimen in spite of the amount of stromal tissue and intratumoral heterogeneity.

In our study P. maurus was represented by two juvenile specimens, and in spite of the evident differences in adult morphology [98] the diagnostic features can be hard to distinguish in juvenile specimens.

The growth rates of cracks at different locations around the circumference of the rotating bending specimens varied little, in spite of the different microstructural orientations of the different locations.

U-U1 specimen and M-U1 specimen satisfy the statement, and U-G specimen also satisfies that in spite of almost single resistant behavior of HPEPC core.

It was found that there is not much improvement of fatigue strength at 107 cycles for specimens with shallow hardened layers in spite of having a high compressive residual stress of about 1000 MPa.

The analyses of the lateral configurations of the specimens were more uniformly distributed, and in spite of the fact that certain differences were observed they were not statistically significant by the Hotelling's t-test of discriminate function.

In spite of type I specimen, type III showed combined cohesive and adhesive failures so that adhesive/adherend failure distributed over the middle width of specimen and cohesive failure happened along the edges.

This is the first time that such specimens revealed good thermoelectric performance after SPS sintering, in spite of the fact that the output power is still one order of magnitude less than that of conventional sintered specimens, as shown in Fig. 5b.