Sentence examples for specimens designed the from inspiring English sources

PJPC collected the specimens, designed the study, carried out the molecular genetics, analyzed and interpreted the data, and drafted the manuscript.

Due to a limited volume of the material prepared by powder metallurgy, small cylindrical specimens designed for the IFMIF irradiation campaign were used.

The revised design method has been applied to test results of twenty-nine haunchedally haunched beam specimens designed by the author and other researchers to confirm its effectiveness.

The reliability of the method was illustrated by analyzing specimens designed to mimic the information likely to be obtained from highly degraded specimens as well as specimens collected from widely separated geographic locations.

This paper, through a comprehensive experimental work, investigates the behaviour of reinforced concrete frame specimens designed to represent the column beam connections in plane frames.

High strain rate experiments were performed using a Split Hopkinson Bar setup, with specimens designed to achieve the desired loading mode, while isothermal experiments were performed with the help of a fluid cell to keep a constant temperature.

The specimens designed for this experiment exceeded the RILEM 7-II-128 requirement on clear cover and featured a 305 mm concrete cylinder to eliminate the potential for splitting and ensure that all of the specimens failed in the same manner (pull-out).

Laboratory specimens, designed to simulate the cross sectional geometry of gas turbine aerofoils, were subjected to particle impacts of varying energy at edge locations in an attempt to represent severe particle ingestion during typical service.

All the specimens have increased load-carrying capacity and reduction of diagonal cracks compared to the specimens designed without cross-diagonal bars in the previous research works (Figs. 9, 10, 11, 12).

The specimens designed as per improved design method showed excellent performance in terms of lateral strength, lateral stiffness, moment rotation characteristics and energy dissipation capacity.

The specimens designed in this study can be classified into full-size specimens.