Sentence examples for specimens at higher from inspiring English sources
However, neither of these criteria adequately explains the progressive coalition of tensile cracks and the final shearing of the specimens at higher confining stresses.
Digital image correlation was used together with high-speed photography to study strain localisation in the tensile specimens at high rates of strain.
This paper aims at presenting the development of an experimental setup to perform confined compression tests of mortar and cement paste specimens at high pressures.
Experiments were conducted for refractory alloy and C/SiC (carbon fiber reinforced silicon carbide composites) and the surface evolution of these specimens at high temperature was recorded.
Computational formulas for the yield and ultimate strengths of the butt weld specimens at high temperatures were also fitted and verified with test data to provide a safety evaluation method for steel structures after a fire.
The paper presents the development of an experimental setup to perform confined compression tests of cementitious paste, mortar, and concrete specimens at high pressures up to 1 GPa as well as the validation of the multi-scale model for the equation of state (EOS) of mortars.
Whereas the collapse of interparticle pores did not initiate reaction, regions of localized macro-deformation initiated reaction inside shear bands at sufficiently high strains (γ∼10), and propagation of the reaction through the entire specimen at higher strains (γ∼20 40).
Looking at the XTEM specimen at higher magnification it was possible to observe the presence of the MWCNT in the SiN matrix.
Spatially, the suppression of wing-like shear bands of post-deformed specimen at higher strain rate leads to milder serrations [22].
The overall energy absorption of the composite tube specimens tested at higher crushing speed was slightly higher than those specimens tested at a lower rate.
The results showed that these properties are influenced by sintering pressure, increasing with an increase on sintering pressure, with the highest improvement for specimens produced at higher pressure.
