Sentence examples for specimens a strain from inspiring English sources

The locations are shown in Figs. 6 and 7. Open image in new window Fig. 7 Position of instrumentations in the specimens a Strain Gauges b LVDTs.

For the human specimens a strain rate of 100%/sec was used for both old and young specimens.

In a bulging, circular specimen, a strain gradient exists from a high value in the centre to a lower one at the edge (Chanliaud et al. 2002).

Carter and Hayes investigated the influence of bone marrow and found that the presence of bone marrow increased the strength, modulus, and energy absorption of specimens at a strain rate of 10.0 per second compared to specimen without bone marrow [ 53].

Except for specimen 1, a strain exceeding 5% (the assumed damage threshold) was only found in 10% or less of the surface area of the tendons.

Beyond a further observation on the so-called lateral inertia confinement effect, special attention is paid to the transient shock wave effect and the propagation of material failure when a specimen is loaded with a strain rate exceeding a theoretical limit for a given specimen size, i.e., in the "excessive" strain rate regime as referred to in this paper.

It follows from Fig.  3e that first voids in the PP 137 specimen were formed at a strain of 1.3 % only.

The results indicated that specimens preheated to 90 °C presented a strain hardening behavior with a pronounced multiple cracking pattern.

One of the striking results is that, for a given displacement rate of the heads of the specimen, a much slower strain rate can be obtained locally in comparison with the strain rate of an equivalent smooth specimen.

However, from a fecal specimen a C. jejuni strain was isolated with secondary resistance to erythromycin (MIC ≥ 256 mg/L) but persistent sensitivity to ciprofloxacin (MIC 0.125 mg/L) and meropenem (MIC 0.008 mg/L).

After consolidation, the specimens were tested under a strain-controlled loading rate of about 1 mm/min to axial strain of approximately 25%, yielding a typical time to failure of about 20 min.