Sentence examples for specimen with small from inspiring English sources

Drilling a hole at the end of the osteotomy reduces the stresses in the lateral cortex and increases the critical opening angle prior to cracking of the opposite cortex in specimen with small correction angles.

The current study suggests that the drill hole (hinge pin) at the end of the horizontal osteotomy reduces the stresses in the contralateral cortex and hence increases the critical opening angle prior to cracking of the opposite cortex in specimen with small correction angles.

Division and analysis of the synovial vascular area by size of vessel demonstrated that medium-sized vessels contributed most to the overall vascular area (79%) within each tissue specimen with small and large vessels contributing in 9.5% and 11.5%, respectively.

The catalyst with larger particles and lower surface area performed better in the degradation of phenol than the specimen with smaller particles and larger surface area.

In the longitudinal stress distribution profiles to z-direction, the tensile stress at the interface between the bond coat and the substrate converts into the compressive stress when the specimen has vertical cracks more than two, while larger magnitude undulation develops for the specimen with smaller number of crack in the radial stress distribution profiles.

An approach on a similar specific energy application for a larger real mass bonded on a large area of the walls of a monopole, and a small specimen with low mass and small adhesive bond area was calculated.

Inversely, the behaviour of specimens without plasma surface treatment differs with particle size, as specimens with small particles present higher values of maximum strain.

The main failure modes for the specimens with small and large scarf angles are adhesive and cohesive, respectively.

Thin walled pipe specimens with small holes were subjected to multi-axial and non-proportional load cycles.

Two large-scale pier specimens, with small amounts of transverse reinforcement, were modeled and tested under a combination of reversed cyclic lateral loading and constant axial loading.

The experimental results showed that the specimens with small diameter-to-thickness ratios failed by extensive plastification on the central part of the tube.