On-line ultrasonic velocity measurements have been made in β-quenched state of zircaloy-2 (A specimen) during heating at different heating rates up to 573 K (B specimen), 603 K (C specimen) and 623 K (D specimen) with holding time periods of 5 h for specimens B and C, and 2 h for specimen D, at the corresponding maximum temperature, by employing a specially designed experimental set-up.
Our observation of increased immuoreactivity to CD11b is consistent with all specimen sections with a maximum score of 12 points after disk injury.
Specimens with the maximum angular deviation (MAD) >20° were rejected as unreliable.
The SED method successfully estimates the load at fracture of nanoscale notched specimens with a maximum discrepancy of 4.7%.
In panel a, triangles/circles depict serum specimens with a maximum OD450 value below/above the cutoff value of the respective peptide ELISA (peptide 1, OD450 ≥ 0.384; peptide 2, OD450 ≥ 0.270; peptide 3, OD450 ≥ 0.280).
The size of the rock cuttings varied between 0.075 mm and 0.4 mm, since it proved promising in preparing specimens with a maximum density of about 80% of the intact rock.
By virtue of the mixing tower system in the site of a super-high arch dam, the wedge splitting specimens with the maximum aggregate size of 150 mm were poured in summer and in winter seasons, respectively.
The wave-like distribution of the load amplitude along the longitudinal axis of the UFTS specimens with a maximum in the minimum cross-section (at about the half length) of the sample permits a selective testing of the different weld zones (weld seam, heat-affected zone and base metal).
Patients who experienced persistence/recurrence had LEEP specimens with smaller maximum diameters than patients who were free of disease.
The final power amplifier functions as a power booster to reach pulse energies necessary for ablation of the biological specimens, with a maximum pulse energy of ∼125 nJ, which corresponds to an average power of 500 mW at 4.08 MHz repetition rate.
