Sentence examples for specimen were approximately from inspiring English sources

The overall electrochemical impedances ranging from 0.01 Hz to 10 kHz of the Al arc-sprayed+hot pressed+anodized (AHA) specimen were approximately 2 orders of magnitude higher than those of the AZ 31 Mg plate, indicating that through the Al arc-spraying and a post-hot pressing and anodizing treatment, the corrosion resistance in AZ31 Mg alloy can be significantly improved.

Though not statistically significantly different, the failure stress and the E-Modulus two typical matE-Modulus twoies [ 42]—of typicaltube specimaterial apropertiesly 30% lower compared to no-tube specimen; this is mainly caused by the approximately 30% larger CSA provoked by the DP tube that is not yet degraded fully after 6 weeks.

The Ac1 temperature of the specimen is approximately 1008 K.

Specimen is approximately 1 meter long and is preserved in oblique ventral view.

Regions near the surfaces in a bent sheet specimen are approximately subjected to plane strain tension or compression.

The rest-state fracture toughness of each specimen was approximately the same as its initiation fracture toughness.

The resected specimen was approximately 6.5 × 4.0 × 3.2 cm (Fig. 2a, b), the center of the solid tumor being located in the middle of the resected specimen.

Three hundred and thirty-five image slices were provided for the pervious concrete specimen and the cropped size of this specimen was approximately 68 mm in diameter.

The material compressive strength of HPEPC is approximately eight times greater than that of EPS mortar, but the flatwise compressive strength of the U-G specimen is approximately five times greater than that of the M-G specimen.

The partial elongation for the STL3 specimen was approximately 75% of the total elongation, as the stress strain curve in Fig. 8 was located lower than the rest of the curves.

As the crack angle of the HP0F1 specimen was approximately 43° (Fig. 4), this result demonstrates that most displacements around the crack occurred in the vertical (y-axis) direction.