Sentence examples for specimen produced by from inspiring English sources

In addition, the fatigue limit of the specimen produced by the CH process was enhanced due to the grain-refined microstructure of the specimen compared to the one of the WD process.

Small dog-bone specimens, produced by compression moulding, were used to test mechanical properties under uniaxial tension.

This study aims to adjust the microstructure of Inconel 718 specimens produced by selective laser melting (SLM).

Compressive strength of geopolymeric specimens produced by class C fly ash and granulated blast furnace slag aggregates has been studied.

This research evaluates the fatigue properties of Ti 6Al 4V specimens produced by the Selective Laser Melting additive manufacturing process.

The specimens produced by SGC very closely simulate the density, aggregate orientation and structural characteristics of asphalt mixture on actual pavement.

This is a piece of evidence of more effective blocking of dislocations' mobility by the grain boundaries in the specimens produced by the mechanochemical activation and provides a higher σ B for them.

The objective of this study is to characterise and to compare the fatigue performance, in terms of S-N data, of the lap joined Ti/PET hybrid specimens produced by laser welding with and without ultrasound aiding.

Agglomeration and bending of equiaxed crystals were studied by microstructural characterization of specimens produced by near-static cooling, high-pressure die casting and Thixomolding®, where the solidifying crystals experience different levels of mechanical stresses.

To verify the ability of presented model in predicting the microstructure of weld zone, the simulated microstructures are compared with the experimental ones in Fig. 8 for the specimens produced by rotational and traverse speeds of 710 rpm × 50 mm/min and 1400 rpm × 25 mm/min.

In this study, the mechanical and physical properties of structural lightweight concrete (SLC) specimens produced by substituting cement with metakaolin (MK) at ratios of 5%, 10%, 15% and 20% w/w were examined, and the corrosion behavior of the reinforcing steel bars embedded in these specimens was investigated.