Sentence examples for specimen increased from from inspiring English sources

After annealing (T5), the breaking elongation of the SLM specimen increased from 15% in the as-fabricated specimen to 30% in the specimen annealed at 350 °C, while the ultimate tensile strength and yield strength decreased from 400 MPa and 250 MPa to 200 MPa and 125 MPa, respectively.

Increasing the Y2O3 content, the density of the sintered specimen increased from 5.524 g/cm3 (98.90% of TD) without any Y2O3 doping to the highest one of 5.583 g/cm3 (99.98% of TD) with a Y2O3 content of 0.2 wt.%.

The Ra of TiO2 specimen increased from 93.1±8.3 to 152.4±0.2 nm after incubation with pH 6.5 ATF and increased to 135±10.7 nm after treatment with pH 5 ATF.

The results indicated that the unconfined compressive strength of treated specimens increased from three to seven times.

The UCS of the specimens increased from 163 kN/m2 for untreated specimen to 928 kN/m2 for specimens mixed with 10% of the quicklime which is about six times greater than the strength of the untreated sample.

The sensitivity, specificity and PPV of these specimens increased from 57.2%, 61.7% and 71.5% at admission to 63.4%, 100%, and 100% at 3 4 weeks, respectively for IgG antibodies, and from 59.7%, 61.3%, and 79.3% at admission to 74.6%, 73.7%, and 89.8%, respectively for IgM antibodies.

The shear strength of polymer treated specimens increased from 100kPaa to 1.2 MPa as the amount of water increased and leveled off above 2.5 μL of water.

If the 211 children with culture-positive pleural effusion specimens are grouped into the empyema category, the percentage of culture-positive specimens increased from 61% to 72% (P < 0.05).

The frequency of CIMP specimens increased from normal mucosa to adenomas with low-grade dysplasia to adenomas with high-grade dysplasia to carcinomas regardless of the marker system used (Fig.  2).

The experimental results show that when the pressure goes up from 5×10−3 to 5×10−2 Pa by bleeding in nitrogen, the ion beam current density decreases by 30% and the surface hardness of the implanted specimen increases from 760 to 950 HV.

The slope of linear fit changed from 0.000 300 to 0.000 711 when the specimen volume increased from 2.5 to 7.5 μL.