Sentence examples for specimen and time from inspiring English sources

However, several reports have shown that conventional and real-time PCR assays were very specific for SARS CoV but lack sensitivity depending on the assay, specimen, and time course of disease.

A power functional relationship is derived between curing factor (k curing  = D t /D 0, where D 0 is the diffusion coefficient of no-cured concrete, D t is the diffusion coefficient of wet cured specimen) and time of wet curing (t curing ) at early ages.

As each contact between a tagged roach and an antenna provided data of specimen ID and time of contact, we were able to calculate the ground speed of the roach migrating through the antenna loops.

The time of warm ischemia was recorded by the surgeon for each specimen and the time of cold ischemia was recorded using radio-frequency identification (RFID) technology 12.

It is found that under the conditions tested, there is a fairly linear correlation between the rate of temperature rise obtained from the specimen and the time rate of hysteresis energy generation.

There was no statistic differences bewteen group I and II in the total number of passes, mean biopsy diameter, mean glomeruli per specimen and mean time of operation and CT scanning.

The purpose of this study is to confirm if SWETZ is a better alternative than LLETZ (used as a type 3 excision of the TZ) concerning the reduction of incomplete excision (compromised surgical margins) of type 2 or 3 TZ and the morbidity related to the surgery and other variables of clinical interest: procedure related bleeding, fragmentation of the specimen and procedure time.

Results of the histologic evaluation as well as from determination of lavage specimen and real-time PCR were analyzed using one-way ANOVA with posthoc Scheffé.

This was accompanied by substantial increases in both axial (5 6 times for CH2 specimens and 4 5 times for CH3 specimens) and hoop strains (6 11 times for CH2 specimens and 5 9 times for CH3 specimens) measured at mid height of the columns.

Experimental results showed that it was feasible to describe monotonic and cyclic tests of stress-controlled mode using one single damage accumulation model based on stress time path, which makes it possible to reduce the number of specimens tested and time-consuming fatigue tests are no longer necessary, since the same information can be obtained from monotonic test data without loss of accuracy.

More information is needed to discover reasons for diversification, such as geographic location of specimens used and times of divergence of lineages.