Sentence examples for specimen and average from inspiring English sources

Bite forces are, however, greatly size dependent, and to facilitate comparison among differently-sized specimens, the Bite Force Quotient [5], [59] was computed for every specimen, and average values were used for regression analyses.

Three measurements were performed per specimen and averaged representing surface roughness before and after stripping at the same region per tooth.

Ratios of m1 m2, m2 m3 and m1 m3 were quantified for each specimen, and averages of these ratios were then calculated for each genus.

Table 4 presents the calculated diffusion coefficients (D) for each specimen and the average D values for each treatment.

Two displacement transducers with an accuracy of 0.01 mm were used for each specimen and their average values were applied to obtain deformations.

Photographs of the static water droplets on each patterned surface are also shown in Figure 2. The static contact angles were measured at more than three points in each specimen, and the average values were acquired.

Based on the above definition using the strain of 0.015, in the present study, the toughness index obtained from each specimen and the average value are presented in Table 2.

PD between each specimen and the average larvae were regressed on ln-CS in all species separately.

The measurements of bladder wall thicknesses were performed at four randomly chosen places at each specimen, and the average value was employed in the analyses.

Concrete compressive strength was obtained at the time of testing using three cube specimens with dimension of 15 cm and one standard cylinder specimen, and all averaged values were converted to a standard cylinder.

Self-stress significantly improves the bond strength of CFST specimens, and the average improvement level is 42.7%.